I've been using the AD2Pi Network Appliance for about 6 months and it has been working great so far with my Smartthings setup. Prior to this new release I had been using CoRE to sync up AlarmDecoder with Smart Home Monitor. This arrangement worked OK but occasionally things would get out of sync.
Last night I installed the new update but it doesn't appear to be working correctly for me. I have version v0.7.6 of the WebApp installed and everything works perfectly from there. On Smartthings the virtual contact sensors / zones are updating immediately (great job on this!). The main thing that is not working correctly is the Arm/Disarm buttons. Essentially nothing appears to be happening when I press either button. The weird thing is that if I triple tap either button then the alarm panel does if fact respond. Since I've confirmed that two-way communication is working fine, my assumption is that something with the new device handler broke compatibility with my PC1555 DSC panel. Both the Arm/Disarm buttons worked fine using the old Device Handlers / SmartApp. Twice now I've tried removing everything and going through the installation process from scratch. Every time I've had the same result. Any assistance with this would be much appreciated!