Hi Kevin,
I got a bundle from you and it is an official image (I did an upgrade from the WebApp) Now, at this point the communication with the Alarm decoder has stopped (it was working before, the WebApp was not, but now I cannot reach the Alarm Decoder), this is the output:
- Code: Select all
pi@alarmdecoder:~ $ telnet localhost 10000
Trying ::1...
Trying 127.0.0.1...
Connected to localhost.
Escape character is '^]'.
!
#
*
the !* and ^ is what I put in there to check if the Decoder was responding. Now, when I run the ser2sock this is the output:
- Code: Select all
pi@alarmdecoder:~ $ ser2sock
ser2sock[1638]: [✔] Using config file: /etc/ser2sock/ser2sock.conf
ser2sock[1638]: [✔] Serial 2 Socket Relay version V1.5.2 starting
ser2sock[1638]: [✘] Fatal error binding to server port 10000 errno: 98
ser2sock[1638]: [✘] ERROR initializing listen socket :Address already in use
ser2sock[1638]: [✘] exiting
I cannot check the version of the AlarmDecoder because it is unresponsive
- Code: Select all
pi@alarmdecoder:~ $ telnet localhost 10000
Trying ::1...
Trying 127.0.0.1...
Connected to localhost.
Escape character is '^]'.
V
and the WebApp version is listed in the previous post.