K command doesn't switch keypad address

General Discussion

K command doesn't switch keypad address

Postby kd7mlg » Tue Mar 23, 2021 8:56 am

Trying to hack my way to observing two partitions with one alarmdecoder, but cannot get the K command to switch keypad addresses on a Vista 20P. All commands are registered (!KPE:) with the original address and I am not able to get the fault detail to appear for partition 2.

Code: Select all
!VER:ffffffff,V2.2a.8.9b-306,TX;RX;SM;VZ;RF;ZX;RE;AU;3X;CG;DD;MF;L2;KE;M2;CB;DS;ER;CR
!CONFIG>MODE=A&CONFIGBITS=ff07&ADDRESS=18&LRR=Y&COM=Y&EXP=NNNNN&REL=NNNN&MASK=ffffffff&DEDUPLICATE=N


Thoughts?
kd7mlg
newt
newt
 
Posts: 17
Joined: Sat Oct 03, 2020 4:40 pm

Return to General

Who is online

Users browsing this forum: No registered users and 2 guests

cron