10.10.0.9: Created page with "category:Vera TOC ==Vera== ===Setup For Network Appliance=== Install AD2USB Plugin (It creates 2 devices, 1 for Panel, 1 for Partition) Upload latest, patched L_Vist..."

2016-03-04T21:19:00Z

Created page with "category:Vera __TOC__ ==Vera== ===Setup For Network Appliance=== *Install AD2USB Plugin (It creates 2 devices, 1 for Panel, 1 for Partition) *Upload latest, patched L_Vist..."

New page

[[category:Vera]]
__TOC__
==Vera==
===Setup For Network Appliance===
*Install AD2USB Plugin (It creates 2 devices, 1 for Panel, 1 for Partition)
*Upload latest, patched L_VistaAlarmPanel1.lua from http://forum.micasaverde.com/index.php/topic,26672.msg272946.html#msg272946
* On the panel device add the overNetwork setting manually:
** Panel device -> Advanced -> New Service
*** New Service: urn:micasaverde-com:serviceId:VistaAlarmPanel1
*** New Variable: overNetwork
*** New Value: 1
** Click 'add'
** Click 'Reload'
* On the panel device change the 'ip' variable to the ser2sock ip:port from your raspberry pi (ex: 192.168.1.100:10000)
* On the partition device set the KeypadAddresses variable to your keypad address.

===Issue going to ready mode after alarm fault===
* On the panel device add the DisableSendStar variable
** Panel device -> Advanced -> New Service
*** New Service: urn:micasaverde-com:serviceId:VistaAlarmPanel1
*** New Variable: DisableSendStar
*** New Value: 1
** Click 'add'
** Click 'Reload'

Setup Vera - Revision history

10.10.0.9: Created page with "category:Vera __TOC__ ==Vera== ===Setup For Network Appliance=== *Install AD2USB Plugin (It creates 2 devices, 1 for Panel, 1 for Partition) *Upload latest, patched L_Vist..."

10.10.0.9: Created page with "category:Vera TOC ==Vera== ===Setup For Network Appliance=== Install AD2USB Plugin (It creates 2 devices, 1 for Panel, 1 for Partition) Upload latest, patched L_Vist..."