10.10.0.9: Created page with "Category:FAQ =Assign a Function Key to a Relay Action= First enter programming mode (Installer Code + 800) Next enable the relay emulation module you wish to emulate on..."

2017-08-18T17:44:53Z

Created page with "Category:FAQ =Assign a Function Key to a Relay Action= First enter programming mode (Installer Code + 800) Next enable the relay emulation module you wish to emulate on..."

New page

[[Category:FAQ]]

=Assign a Function Key to a Relay Action=

First enter programming mode (Installer Code + 800)

Next enable the relay emulation module you wish to emulate on the AlarmDecoder settings - note emulating relays in existing addresses can cause conflicts.

Only emulate the relay number you need.

==Programming==
The first step is to assign a function key to a device activation
# *57
# Press the function key you want to assign (ex: D)
# Press * to continue
# Assign this key to 07 (Device Activation / Change Dev State)
# Exit

Then you need to map the output.
# *79
# Select Output number: 05 (example)
# Output Type 1 (Relay)
# Module Addr: 13 (2nd emulated relay on alarmdecoder)
# Position: 1
# Exit

Then you need to define the output action

# *80
# Select an unused output function number. Example "07"
# Activate by: Zone Type (2)
# Enter the Zone Type function key (66)
# For the Output Action, I've selected close for 2 secs (1)
# Output Number (I use the same as the Output function number: "07"
# Exit

Assign Function Key Relay - Revision history

10.10.0.9: Created page with "Category:FAQ =Assign a Function Key to a Relay Action= First enter programming mode (Installer Code + 800) Next enable the relay emulation module you wish to emulate on..."