WebApp - Forbidden Page, no permission (new setup)

General Discussion

WebApp - Forbidden Page, no permission (new setup)

Postby Ken » Wed Aug 15, 2018 10:26 am

Hello, setup my AlarmDecoder over the weekend, was able to see my Vista 20p panel, but could not input anything into the Web Keypad (could see the keypad messages though). Today went back to troubleshoot again, try to access the WebApp, get Forbidden Page, no permission.
Need help on how to get back into the WebApp and
How to get my enable keypad entry on the WebApp keypad

Thanks
Ken
newt
newt
 
Posts: 1
Joined: Wed Aug 15, 2018 10:15 am

Re: WebApp - Forbidden Page, no permission (new setup)

Postby kevin » Thu Sep 06, 2018 5:04 pm

sounds like you need to enable an address in your panel for the alarmdecoder

after that, you can ssh in to your device and issue the following commands to factory and go back through setup of the device

cd /opt/alarmdecoder-webapp
sudo rm instance/db.sqlite
python manage.py initdb
sudo reboot
Not an employee of the company. Just here to help and keep things clean.
kevin
Site Admin
Site Admin
 
Posts: 992
Joined: Fri Aug 16, 2013 10:10 am


Return to General

Who is online

Users browsing this forum: No registered users and 3 guests