Page 1 of 1
Do these work with FireLite/Notifier/Silent Knight panels?
Posted:
Thu Jan 04, 2018 5:34 pmby jelimoore
Like the title says, I was curious if these work with honeywell-brand fire alarm panels. They are honeywell-based panels that a lot of people re-brand (ADT for one) and are quite popular in the fire alarm enthusiast area. If I could get one of these modules to work with a panel that would be amazing.
Note I do not own one of these panels right now, I'm debating getting either an MS-25 or MS-9200UDLS. I saw this project and it piqued my curiosity.
Re: Do these work with FireLite/Notifier/Silent Knight panel
Posted:
Thu Jan 04, 2018 7:23 pmby kevin
Sorry I doubt these are supported
Re: Do these work with FireLite/Notifier/Silent Knight panel
Posted:
Fri Jan 05, 2018 3:56 pmby jelimoore
Crap. If I got one, would there be any easy way to reverse engineer the protocol on the panel? I'd imagine it's not too different than standard residential fire/burg alarms. FYI I do have quite a bit of electronics/embedded device experience so if I did get this panel I would be willing to try and reverse the protocol.
I've found a cheap panel on ebay, the dialer is dead (not a big deal for me since I don't really want it calling a monitoring company for now).
Re: Do these work with FireLite/Notifier/Silent Knight panel
Posted:
Fri Jan 05, 2018 6:33 pmby kevin
You can potentially coordinate with nu tech to get them to support it, email them at
ad2usb@support.nutech.com to discuss
You can turn on debug mode in the beta firmware and try and get a handle on the communications - as long as there is an ECP bus for a keypad to connect to.