alarmdecoder.com

Finally hooked up my AD2Pi Network Appliance to my Safewatch Pro 3000. Everything works, I can instantly arm/disarm from the app there is a little delay going the other way.
I don't understand what to do with the sensors. The instructions stated "20. Zone sensors may be configured to open and close themselves when a zone is faulted. For example, specifying zone 7 for Zonetracker Sensor #1 would trip that sensor whenever zone 7 is faulted"
Another thing is that I can't seem to get a notification setup for every arm/disarm or alarm.

When installing the smartthings code you are able to configure your sensors. You can map a zone number to a sensor. So when a sensor gets tripped you can perform actions. So you can map say... zone 1 to sensor #1 and when zone #1 faults it will trip sensor #1 in smartthings

Notifications, which notifications are you having trouble with? There is documentation in our wiki for each of them https://www.alarmdecoder.com/wiki/index ... ifications

I've removed your link because it violates our spam/advertisement policy.