firmware is 2.2a.1
My two keypads work fine. I set the AD2USB to address 31 but don't know how to answer the other prompts so I press ENTER.
All I get are dots. Can't see any output from the panel and can't seem to send anything.
- Code: Select all
!Ademco Keypad Emulator V2.2a.1
!Copyright (C) 2008-2010 Nu Tech Software Solutions, Inc.
!Reproduction without permission is prohibited
!By Sean Mathews <drwho at f34r.com>
!For support email general@support.nutech.com
!www.NuTech.com
!Reading configuration.
!UART init.
!Ready. Press ! for configuration.
!>Keypad Address (31) :>
!>Code (0000) :>
!Zone Expanders Y/N Max allowed: 01
!>expander module #01 ZN 09-16 (N) :>
!>expander module #02 ZN 17-24 (N) :>
!>expander module #03 ZN 25-32 (N) :>
!>expander module #04 ZN 33-40 (N) :>
!>expander module #05 ZN 41-48 (N) :>
!Relay Modules Y/N Max allowed: 04
!>relay module #01 (N) :>
!>relay module #02 (N) :>
!>relay module #03 (N) :>
!>relay module #04 (N) :>
!Reading configuration.
!UART init.
!Sending............................