alarmdecoder.com

I just installed my first AD2USB. I can see messages form my panel, but I am not able to send commands to the panel.

using the Windows GUI tool I see this in the logs:

DISARMED CHIME Ready to Arm "
12/31/2013 6:43:41 PM [1000000110000000----],008,[f70000031008001c28020000000000]," DISARMED CHIME Ready to Arm "
12/31/2013 6:43:50 PM [1000000110000000----],008,[f70000031008001c28020000000000]," DISARMED CHIME Ready to Arm "
12/31/2013 6:43:57 PM !Sending.done
12/31/2013 6:43:58 PM !Sending.done
12/31/2013 6:43:58 PM !Sending.done
12/31/2013 6:43:59 PM !Sending.done
12/31/2013 6:44:00 PM !Sending.done
12/31/2013 6:44:00 PM [1000000110000000----],008,[f70000031008001c28020000000000]," DISARMED CHIME Ready to Arm "

What panel? Have you assigned a keypad address that is unused to the ad2usb that is enabled in the panel programming?