Page 1 of 1

SE protocol incompatibility with ad2usb

PostPosted: Wed May 01, 2019 10:24 am
by trombe
Just wondering if anyone bumped into Ademco SE panel not sending commands properly from ad2usb when in Alarm state, here's some debug info:

[00010001010000000A0-],001,[f7000000800100000a000000000000],"ALARM 01 ZONE 01 "
!DBG:<ff><ff><ff>*<ff><ff>

!Sending.!DBG:(98)(08)(86)(cc)(fc)<ff>(98)(f8)
!DBG:*01*[01][00][00][0a]<ff>(98)(08)(86)(cc)(fc)<ff>(98)(f8)
!DBG:*01*[01][00][00][0a]<ff>(98)(08)(86)(cc)(fc)<ff>(98)(f8)
<this continues until the next message>

Thanks!